Tuner DVB-T-2 LTC terrestrial TV DVB3 with Wi-Fi function and programmable remote H.265

Codecs: MPEG-1 (layer III), MPEG-2 MP@MP.HL, MPEG-4 AVC/H.265 HP@L4, WMA, AQC3, AAC, Dolby Digital Plus

Modulation: QPSK, 16QAM, 64QAM, 256QAM

HIGH PICTURE QUALITY Only a good HD STB decoder will guarantee reception of all free-to-air programmes of digital terrestrial television DVB-T MPEG-4 and the latest digital terrestrial television system DVB-T and DVB-T2. Support for the modern compression method H.265 / HVEC allows high picture quality to be maintained while significantly reducing bandwidth. The built-in audio decoder E-AC-3 (Dolby Digital Plus) guarantees sound reception on the TV. The device receives TV programmes broadcast in high definition Full HD 1080p.

WI-FI CONNECTIVITY The decoder is equipped with a built-in Wi-Fi receiver, enabling the device to connect to the internet. Internet connectivity greatly expands the device's capabilities and allows playback of audio/video materials available on the network.

UNIVERSAL CONNECTORS The tuner can be connected to any type of TV thanks to the HDMI connector and the traditional EURO connector. The decoder is fitted with a very sensitive tuner head. Signal level indicators allow the antenna to be aligned correctly. The device can power an antenna amplifier via the decoder with a voltage of 5 V. Furthermore, thanks to advanced multimedia functions and a USB port, users can watch films, browse photos and listen to music from external memory media.

REMOTE CONTROL Another advantage of the set is the remote control, equipped with 4 programmable buttons. This means one remote can be programmed to operate both the decoder and the TV, which greatly simplifies using both devices. Only one remote is needed for full operation. The LTC tuner means convenience and ease of use.

BUTTON PROGRAMMING The remote can be programmed with 4 buttons: TV/AV, VOL-, VOL+, POWER. To programme the buttons:

1. Hold the „SET” button for 3 seconds until the red light located in the power button lights up steadily.

2. Briefly press the button to be programmed – the red light will start flashing. Point the remotes at each other and press the button whose function is to be copied to the remote.

3. The light on the remote will flash, then light up steadily. This means the remote has accepted the function and is ready to programme the next buttons.

4. To programme the next button, repeat the operation from point 2.

5. To finish programming the remote's buttons, press the „SET” button; the light will go out and the remote will switch from learning mode to normal operation mode.

WARNING! The tuner does not support the broadcast resolution of 1920 x 540 pixels. This may result in problems or an inability to receive certain TV channels. WARNING! The tuner does not support the broadcast resolution of 1920 x 540 pixels. This may result in problems or an inability to receive certain TV channels.