Kidde dual smoke and carbon monoxide detector K10SCO

K10SCO is a dual smoke and carbon monoxide alarm equipped with a voice alarm and two independent sensors. The optical sensor detects fire alarms, while the electrochemical sensor detects carbon monoxide (CO).

When fire and/or a dangerous level of carbon monoxide is detected, an audible alarm with a sound level of 85dB, a visual alarm (red LED) and a voice message (in English) informing of the type of threat detected are activated.

The Test/Reset button allows control and operation of the alarm. The device's memory records information on the detection of a dangerous CO concentration or fire hazard. This allows the user to check whether, for example, carbon monoxide was emitted during their absence from the room.

The alarm can be mounted on either the ceiling or the wall. It is powered by 2 x 1.5V AA alkaline batteries. This solution allows the alarm to be installed in the optimal location in the room and provides protection also in the event of a mains power failure. The built-in automatic performance monitoring system constantly monitors, among other things, the status of the sensors and internal circuits. If a fault is detected, the appropriate signalling for the fault is activated.

K10SCO is a device of the highest possible standards. It complies with both the PN-EN14604:2006P (EN14604:2005) standard for domestic smoke alarms and the EN50291-1:2018 standard for carbon monoxide alarms. Compliance with these standards has been confirmed by the independent, notified testing body TÜV Rheinland. In addition, K10SCO is marked with the B construction mark confirming compliance with the Polish standard PN-EN 50291-1:2018+AC:2021 for domestic carbon monoxide detectors. Testing was carried out by the Central Mining Institute for Fire Protection, Józef Tuliszkowski National Research Institute (CNBOP-PIB).

The device is covered by a 10-year warranty. It will also notify you of the need to replace the device 10 years after power activation.

Recommended installation locations: near the kitchen, in the living room, lounge, dining room, bedroom, cellar, loft, and areas where electrical appliances that could cause a fire are used, as well as areas with equipment that may be a source of carbon monoxide, e.g. fireplaces, electric or gas room heaters, etc.

ADVANTAGES

Patented Kidde electrochemical sensor for carbon monoxide detection

High-quality Kidde optical sensor designed to detect fire hazards

At least 40% longer operating life compared with most sensors available on the market

Loud audible alarm and visual signal in the form of an electroluminescent LED

Voice messages distinguishing the detected threat

Test / Reset button for control and operation of the device

Hush® function allowing the audible fire alarm signal to be silenced

Battery power ensuring protection also during a mains power failure

Special design allowing ceiling or wall mounting

Locking mechanism protecting against accidental removal of the alarm

Low battery signalling

Signalling of malfunction and end of operating life

Simple installation and operation

B construction mark

National Declaration of Performance Certificate confirming compliance with the Polish standard PN-EN 50291-1:2018+AC:2021

CNBOP-PIB certificate confirming compliance with the Polish standard PN-EN 50291-1:2018+AC:2021

Compliance with PN-EN 14604:2006 (EN14604:2005) confirmed by the independent, notified testing body TÜV Rheinland

TÜV Rheinland certificate confirming compliance with the EN50291-1:2018 standard

10-year warranty