Kidde carbon monoxide detector with display K5DCO

Carbon monoxide detector with display K5DCO, equipped with a Kidde electrochemical sensor guaranteeing a 10-year operating life. Battery power allows the detector to be installed in the optimal location in the room and provides protection also in the event of a mains power failure.

The built-in LCD display shows the carbon monoxide concentration in the range from 0 to 999 PPM. CO concentration is measured every second. Exceeding the permissible CO level is signalled visually (red LED) and audibly (loud, pulsing alarm at a volume of 85dB).

The detector has a test / reset button allowing the device to be checked and the alarm signal to be reset, as well as a button which, when pressed, displays the highest detected CO level stored in the sensor's memory. The detector also has a function informing about alarm activation within the last 14 days. This allows the user to make sure that no carbon monoxide was emitted in the room during their absence.

The function control system continuously monitors, among other things, the sensor, internal circuits and battery status. In the event of malfunction or low battery charge, the yellow LED flashes, the appropriate graphic information is shown on the LCD panel and a warning sound is activated. The detector is also equipped with a simulated test function allowing quick verification of the sensor's correct response to CO test gas.

Thanks to its specially designed housing, the detector can be mounted on a wall or placed on a flat surface, e.g. on a bedside table near the bed. After 10 years from power activation, the detector will remind you that it needs replacing.

K5DCO is marked with the construction mark B confirming compliance with the Polish standard PN-EN 50291-1:2018+AC:2021 for domestic carbon monoxide detectors. Testing was carried out by the Scientific and Research Centre for Fire Protection – National Research Institute named after Józef Tuliszkowski (CNBOP-PIB). It also holds a BSI certificate confirming compliance with the requirements of standard BS EN 50291-1:2018, issued by the British Standards Institution.

FEATURES

Electrochemical technology – one of the most precise electrochemical sensors in the world

LCD display with a maximum reading of 999 PPM

40% longer operating life compared with other detectors available on the market

Loud alarm signal

Test/Reset button – for checking and operating the device

Peak concentration button – for reading the highest detected CO concentration stored in memory

Battery power providing protection also during a mains power failure

Can be mounted on a wall or ceiling, or placed on a flat surface

Function informing about alarm activation within the last 14 days

Signalling of malfunction and end of operating life

Low supply voltage signal

Additional LED signalling device malfunction and end of service life

Simple installation and operation

Compact dimensions, low weight, attractive and durable housing

Very low running cost

Construction mark B

National Certificate of Constancy of Performance confirming compliance with the Polish standard PN-EN 50291-1:2018+AC:2021

CNBOP-PIB certificate confirming compliance with the Polish standard PN-EN 50291-1:2018+AC:2021

BSI certificate confirming compliance with standard EN50291-1:2018

7-year warranty